Seagate ST118273WC Podręcznik Użytkownika Pobierz pdf (Strona 40)

Configuring a Peripheral (A Summary)

2-6 Peripherals Configuration (R1001H) HP-UX version 11.00.01

In this case, 11/10/12 is the desired slot for the K118 device, and

/etc/stratus/prom_code/ioa18_async.pm is the firmware file name you

want to burn on this device.

Configuring a Peripheral (A Summary)

First, prepare for configuring the peripheral by gathering information required for

the successful configuration of the peripheral. The considerations vary depending

on the peripheral type and are discussed in each peripheral-specific chapter. For

example:

■ Have you prepared the location for the peripheral device?

■ To what interface are you connecting the peripheral?

■ What device drivers are required by the peripheral device?

The System Administration Manager (SAM) and the addhardware command

provide a simple interface for configuring the HP-UX operating system for

standard peripheral devices.

On Continuum systems, the kernel is automatically loaded back into the LIF when

the mk_kernel command is invoked or the system is rebooted. The

addhardware command automatically runs the system utilities needed to remake

the kernel and bring the new device online. This operation can be performed on a

running system. There is no need to reboot the Continuum system to add new

replacement hardware. SAM will also automatically reburn the flash card on

Continuum Series 400 systems.

Here is how to update the Continuum system for most standard devices, or most

additional and replacement devices of a previously configured type:

1. Configure system components for the new peripheral according to your

hardware documentation.

2. Power on the peripheral device(s).

3. Run the addhardware command. The HP-UX operating system will scan for

the new hardware and make the necessary updates to the HP-UX operating

system file. The device special files required by the new peripheral device will

be created in the appropriate /dev directories.

4. Verify the configuration by invoking the ioscan command (see the

ioscan(1M) man page for more information).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 85 86

Brak uwag

Seagate ST118273WC Podręcznik Użytkownika Strona 40