Seagate ST118273WC Podręcznik Użytkownika Pobierz pdf (Strona 44)

Configuring Console Controller Serial Ports

3-4 Peripherals Configuration (R1001H) HP-UX version 11.00.01

5. The system next displays the following three prompts:

power up on boot [1]:

allow host config [0]:

shadow console setup [0]:

To change a default value, enter the new value at the appropriate prompt.

These prompts serve the following purposes:

–The power up on boot prompt allows you to set whether the system

automatically powers up when power is restored to the system after being

shut down. By default (1) the system powers up automatically when

booting; that is, the console controller turns on power to all of the other

boards in the system. Alternatively, if you enter 0 at this prompt, the

system will not power up at boot, but will immediately enter the console

command menu and wait for the administrator to enter a command. The

power up on boot prompt applies to Continuum Series 600 and 1200

systems only; it has no effect on Continuum Series 400 systems.

–The allow host config prompt sets whether the host can override the

configuration settings for the console port. (This setting applies to the

secondary port if the shadow console setup value is set to 1 or 2.) By

default (0), only the port configuration values read from the config

partition are used; requests from the host to change the port configuration

are ignored. To allow the host to specify a different port configuration,

enter 1 at this prompt.

–The shadow console setup prompt sets the function of the auxiliary

port. You can enter one of the following values:

0 Do not enable the secondary console port (the default).

1 Enable the secondary console port as a shadow to the main console,

and report all input and output from the main console.

2 Enable the secondary console port as a shadow to the main console

port, but report output only from the main console (discard input).

3 Enable the secondary console port as a fully independent channel.

4 Enable the secondary console port as a UPS connection port. (Connect

the UPS directly to this port; no other configuration is necessary.)

NOTE

For information on installing a UPS, see your hardware installation

documentation.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 85 86

Brak uwag

Seagate ST118273WC Podręcznik Użytkownika Strona 44