
Configuring the Meridian 1 12-7
Establishing the AML using an ESDI card
Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999
Establishing the AML using an ESDI card
Introduction
You can use an ESDI card to establish the AML between
Meridian Mail and the Meridian 1 regardless of X11’s software
release. However, the commands used to program the link may
vary based on the software release. For more, information refer
to the following sections:
• Defining the ESDI and the AML (see below)
• “Enabling ESDI ports (ESDI, X11 Release 17 or earlier)”
on page 12-13
• “Activating the AML (ESDI, X11 Release 18 or later)” on
page 12-14
To establish the AML between the Meridian 1 and Meridian
Mail, using an MSDL card, follow the steps outlined in
“Establishing the AML using an MSDL card” on page 12-15.
Defining the ESDI and
the AML
Overlay 17 is used, regardless of X11’s software release, to
define the ESDI and the AML on the Meridian 1. However, the
responses to the prompts vary based on the software release.
Configuring the ESDI
and the AML
To configure the ESDI and the AML, follow these steps.
Note: The shaded areas in “Overlay 17—ESDI and AML
configuration (X11 Release 17 or earlier)” on page 12-8 apply
to Network Message Service systems (NMS) systems only.
Step Action
1Enter LD 17 to load Overlay program 17.
2 Enter the appropriate response to the prompt. Refer to “Overlay
17—ESDI and AML configuration (X11 Release 17 or earlier)”
on page 12-8, for link configuration for X11 software Release
17 or earlier; refer to “Overlay 17—MSDL and AML
configuration” on page 12-15 for link configuration for X11
software Release 18 or later.
3Enter **** to exit from Overlay program 17.
Komentarze do niniejszej Instrukcji